LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 411 (On-Board Diagnostic [Automatic Transaxle]) >> DTC P0711 >> Diagnostic procedure

Diagnostic procedure

WARNING: This page is about a different car, the 2005 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
DTC P0711 - DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED 
  • Has FREEZE FRAME DATA been recorded?
 Yes Go to the next step.
No Record the FREEZE FRAME DATA on the repair order, then go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Check for related Service Bulletins and/or online repair information availability.
  • Is any related repair information available?
 Yes Perform repair or diagnosis according to the available repair information.
  • If vehicle is not repaired, go to the next step.
No Go to the next step.
3 INSPECT TFT SENSOR VOLTAGE 
  • Connect voltmeter to TCM terminal 1F.
  • Turn ignition switch to ON (engine OFF).
  • Is TCM terminal voltage 1.55 V  ?
 Yes Go to the next step.
No Go to Step 6.
4 VERIFY CURRENT INPUT SIGNAL STATUS - IS CONCERN INTERMITTENT OR CONSTANT? 
  • Start engine.
  • Drive vehicle at 60 km/h {37 mph} or above  for 10 min or more  .
    • ATF 20°C {68°F}. 1.55 V 
    • ATF 60 °C {140°F}: 0.7V 
  • Does TCM terminal voltage change?
 Yes Go to Step 6.
No Go to the next step.
5 INSPECT TERMINAL CONDITION 
  • Turn ignition switch to OFF.
  • Disconnect the terminal component No.2 (8-pin).
  • Inspect terminals for corrosion.
  • Are terminals okay?
 Yes Replace the TFT sensor, then go to the next step.
No Repair or replace the terminals, then go to the next step.
6 VERIFY TROUBLESHOOTING OF DTC P0711 COMPLETED 
  • Make sure to reconnect all disconnected connectors.
  • Clear DTC from memory using WDS or equivalent.
  • Decrease ATF temperature to 20 °C {68 °F} or below  .
  • Drive vehicle at 60 km/h {37 mph} or above  for 10 min or more  .
  • Is same DTC present?
 Yes Replace the TCM, then go to the next step.
(See TCM REMOVAL/INSTALLATION .)
No Go to the next step.
7 VERIFY AFTER REPAIR PROCEDURE  Yes Go to the applicable DTC inspection.
No Troubleshooting completed.
scientia non olet · About LEMON Manuals