Key Replacement Or Addition (Customer Supplied Only One Or No Valid Keys)
WARNING: This page is about a different car, the 2002 Mazda 626 and 2001 Mazda 626. However, it is still accessible from the selected car via links, so may be relevant.
- Cut new transponder equipped key(s). Using new key, turn ignition switch to ON position, then to LOCK position 5 times. Turn new key to ON position. SECURITY light should be flashing at a 300 millisecond interval. Turn new key to LOCK position and wait about 5 minutes until SECURITY light flashing has decreased to a 1.2 second interval.
- Input code word. See INPUTTING CODE WORD . SECURITY light should stop flashing and stay illuminated. Start engine with new key. SECURITY light should illuminate for 1-2 seconds and engine should continue to run. Turn new key to LOCK position and remove key.
- Using new second key, start engine. SECURITY light should illuminate for 1-2 seconds and engine should continue to run. Turn new second key to LOCK position and remove key.
- Repeat step 3 with valid key or new third key. Repeat step 3 with each new key, up to 8 keys total. After 30 seconds, program will quit automatically.