LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 38 (Automatic Transmission - Diagnosis [La4A-El]) >> Programming >> Immobilizer System >> Inputting Code Word

Inputting Code Word

WARNING: This page is about a different car, the 2002 Mazda 626 and 2001 Mazda 626. However, it is still accessible from the selected car via links, so may be relevant.
  1. Code word is comprised of 8 digits from 1-9. The code word is part of immobilizer unit from manufacturer. To obtain code word, call manufacturer with immobilizer unit serial number.
  2. The immobilizer unit code word is input into PCM by cycling ignition key and counting number of SECURITY light flashes. Wait about 5 minutes until SECURITY light flashing has decreased to a 1.2 second interval. Input code word with SECURITY light sequence.
  3. Turn ignition switch to ON position for number of flashes of first code word digit. Turn ignition switch to LOCK position for at least one flash and less than 30 seconds. Repeat procedure for each code word digit. When code word is registered correctly, SECURITY light will stop flashing and stay illuminated. Continue immobilizer system reprogram procedure.
scientia non olet · About LEMON Manuals