Selector Lever Component Inspection

WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable.
Remove the center console.
Remove the dashboard completely. (See DASHBOARD REMOVAL/INSTALLATION .)
Disconnect the selector lever component connector.
Inspect for continuity at the selector lever component.
- If there is any malfunction, adjust the selector cable. (See SELECTOR CABLE ADJUSTMENT .)
  
  Fig 1: Continuity Table For Selector Lever Component
  Courtesy of MAZDA MOTORS CORP.
  
  Fig 2: Identifying Selector Lever Connector Terminals
  Courtesy of MAZDA MOTORS CORP.