Symptom Troubleshooting Item Table
WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Use the chart below to verify the symptoms of the trouble in order to diagnose the appropriate area.DESCRIPTION CHART
No. TROUBLESHOOTING ITEM DESCRIPTION Go To 1 - Vehicle does not move in D range, or in R position
- Vehicle does not move when accelerator pedal is depressed.
(See NO. 1 VEHICLE DOES NOT MOVE IN D RANGE, OR IN R POSITION .) 2 - Vehicle moves in N position
- Vehicle creeps in N position.
- Vehicle creeps if brake pedal is not depressed in N position.
(See NO. 2 VEHICLE MOVES IN N POSITION .) 3 - Vehicle moves in P position, or parking gear does not disengage when P position is disengaged
- Vehicle rolls when on a downward slope and tires do not lock in P position.
- Tires locked when P position is disengaged, vehicle does not move in D range, and R position when accelerator pedal is depressed, and engine remains in stalled condition.
(See NO. 3 VEHICLE MOVES IN P POSITION, OR PARKING GEAR DOES NOT DISENGAGE WHEN P IS DISENGAGED .) 4 - Excessive creep
- Vehicle accelerates in D range, and R position when accelerator pedal is not depressed.
(See NO. 4 EXCESSIVE CREEP .) 5 - No creep at all
- Vehicle does not move in D range, or R position when idling on flat paved road.
(See NO. 5 NO CREEP AT ALL .) 6 - Low maximum speed and poor acceleration
- Vehicle acceleration is poor at start.
- Delayed acceleration when accelerator pedal is depressed while driving.
(See NO. 6 LOW MAXIMUM SPEED AND POOR ACCELERATION .) 7 - No shifting
- Single shift range only.
- Sometimes shifts correctly.
(See NO. 7 NO SHIFTING .) 8 - Does not shift to 6GR
- Vehicle does not upshift from 5GR to 6GR even though vehicle speed increased.
- Vehicle does not shift to 6GR even though accelerator pedal is released in D range at 80 km/h {50 mph}.
(See NO. 8 DOES NOT SHIFT TO 6GR .) 9 - Abnormal shifting
- Shifts incorrectly (incorrect shift pattern).
(See NO. 9 ABNORMAL SHIFTING .) 10 - Frequent shifting
- Downshifting occurs suddenly even when accelerator pedal is depressed slightly in D range.
(See NO. 10 FREQUENT SHIFTING .) 11 - Shift point is high or low
- Shift point considerably different from automatic shift diagram.
- Shift delays when accelerating.
- Shift occurs suddenly when accelerating and engine speed does not increase.
(See NO. 11 SHIFT POINT IS HIGH OR LOW .) 12 - Torque converter clutch (TCC) non-operation
- TCC does not operate when vehicle reaches TCC operation range.
(See NO. 12 TORQUE CONVERTER CLUTCH (TCC) NON-OPERATION .) 13 - No kickdown
- Does not downshift when accelerator pedal is fully depressed within kickdown range.
(See NO. 13 NO KICKDOWN .) 14 - Engine flares up or slips when upshifting or downshifting
- When accelerator pedal is depressed, engine speed increases normally but vehicle speed increases slowly.
- When accelerator pedal is depressed while driving, engine speed increases but vehicle speed does not increase.
(See NO. 14 ENGINE FLARES UP OR SLIPS WHEN UPSHIFTING OR DOWNSHIFTING .) 15 - Engine flares up or slips when accelerating vehicle
- Engine flares up when accelerator pedal is depressed for upshifting.
- Engine flares up suddenly when accelerator pedal is depressed for downshifting.
(See NO. 15 ENGINE FLARES UP OR SLIPS WHEN ACCELERATING VEHICLE .) 16 - Judder upon torque converter clutch (TCC) operation
- Vehicle jolts when TCC is engaged.
(See NO. 16 JUDDER UPON TORQUE CONVERTER CLUTCH (TCC) OPERATION .) 17 - Excessive shift shock from N to D or N to R position/range
- Strong shock is felt when shifting from N to D or N to R position/range at idle.
(See NO. 17 EXCESSIVE SHIFT SHOCK FROM N TO D OR N TO R POSITION/RANGE .) 18 - Excessive shift shock is given when upshifting and downshifting
- Excessive shift shock is felt when depressing accelerator pedal to accelerate at upshifting.
- During cruising, excessive shift shock is felt when depressing accelerator pedal at downshifting.
(See NO. 18 EXCESSIVE SHIFT SHOCK IS GIVEN WHEN UPSHIFTING AND DOWNSHIFTING .) 19 - Excessive shift shock on torque converter clutch (TCC)
- Strong shock is felt when TCC is engaged.
(See NO. 19 EXCESSIVE SHIFT SHOCK ON TORQUE CONVERTER CLUTCH (TCC) .) 20 - Noise occurs at idle when vehicle is stopped in all positions/ranges
- Transaxle is noisy in all positions and ranges when vehicle is idling.
(See NO. 20 NOISE OCCURS AT IDLE WHEN VEHICLE IS STOPPED IN ALL POSITIONS/RANGES .) 21 - Noise occurs at idle when vehicle is stopped in D range, or in R position
- Transaxle is noisy in driving ranges when vehicle is idling.
(See NO. 21 NOISE OCCURS AT IDLE WHEN VEHICLE IS STOPPED IN D RANGE, OR IN R POSITION .) 22 - No engine braking in 1GR position of M range
- Engine speed drops to idle but vehicle coasts when accelerator pedal is released during cruising at medium to high speeds.
- Engine speed drops to idle but vehicle coasts when accelerator pedal is released when in M range (1GR) at low vehicle speed.
(See NO. 22 NO ENGINE BRAKING IN 1GR POSITION OF M RANGE .) 23 - Transaxle overheats
- Burnt smell emitted from the transaxle.
- Smoke is emitted from the transaxle.
(See NO. 23 TRANSAXLE OVERHEATS .) 24 - Engine stalls when shifted to D range, or in R position
- Engine, stalls when shifting from N or P position to D range or R position at idle.
(See NO. 24 ENGINE STALLS WHEN SHIFTED TO D RANGE, OR IN R POSITION .) 25 - Engine stalls when driving at slow speeds or stopping
- Engine stalls when brake pedal is depressed while driving at low speed or stopping.
(See NO. 25 ENGINE STALLS WHEN DRIVING AT SLOW SPEED OR STOPPING .) 26 - Starter does not work
- Starter does not work even when P or N position is selected.
(See NO. 26 STARTER DOES NOT WORK .) 27 - Gear position indicator light does not illuminate in M range
- Gear position indicator light in instrument cluster does not illuminate in M range with ignition switch at ON.
(See NO. 27 GEAR POSITION INDICATOR LIGHT DOES NOT ILLUMINATE IN M RANGE .) 28 - Gear position indicator light illuminates in D range or P, N, R positions
- Gear position indicator light in instrument cluster illuminates in D range or P, N R positions with ignition switch at ON.
(See NO. 28 GEAR POSITION INDICATOR LIGHT ILLUMINATES IN D RANGE OR P, N, R POSITIONS .) 29 - Does not upshift in M range
- Gear position indicator light in instrument cluster illuminates but vehicle does not upshift when selector lever is pushed to "+" side.
(See NO. 29 DOES NOT UPSHIFT IN M RANGE .) 30 - Does not downshift in M range
- Gear position indicator light in instrument cluster illuminates but vehicle does not downshift when selector lever is pushed to "-" side.
(See NO. 30 DOES NOT DOWNSHIFT IN M RANGE .)