No. 7 No Shifting
WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
DESCRIPTION AND POSSIBLE CAUSE
| 7 |
No shifting |
| DESCRIPTION |
- Single shift range only.
- Sometimes it shifts correctly.
|
| POSSIBLE CAUSE |
- When the gear position is fixed in 3GR or 5GR due to the fail-safe operation, malfunction is in the ATX.
- Perform malfunction diagnosis according to No. 6 "LOW MAXIMUM SPEED AND POOR ACCELERATION".
- Clutch burnt (C1 clutch, C2 clutch, C3 clutch, B1 brake)
- Line pressure low
- Incorrect throttle position signal
- VSS malfunction
- Input/turbine speed sensor malfunction
- Sensor GND malfunction
- Shift solenoid C malfunction
- Shift solenoid D malfunction
- Shift solenoid E malfunction
- Line pressure control solenoid malfunction
- Shift solenoid F malfunction
- Control valve body malfunction
- 3GR or 5GR is fixed (Operation in fail-safe function)
- Short or open circuit in wiring harness
- Poor connection of connector
- Poor ground of shift solenoid
- Malfunction of electronic parts of output and input system
|