No. 22 No Engine Braking In 1GR Position Of M Range: Notes
WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
DESCRIPTION AND POSSIBLE CAUSE
| 22 |
No engine braking in 1GR position of M range |
| DESCRIPTION |
- Engine speed drops to idle but the vehicle coasts when the accelerator pedal is released during cruising at medium to high speeds.
- Engine speed drops to idle but the vehicle coasts when accelerator pedal is released when in M range (1GR) at low vehicle speed.
|
| POSSIBLE CAUSE |
- Clutch slippage, burnt (B2 brake)
- Line pressure low
- VSS malfunction
- Input/turbine speed sensor malfunction
- Shift solenoid A or B malfunction
- Sensor GND malfunction
- Control valve body malfunction
NOTE:
- Before following the troubleshooting steps, make sure that the Automatic Transaxle On-Board Diagnostic and Automatic Transaxle Basic Inspection are conducted. (See
BASIC INSPECTION .)
|