LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 363 (On-Board Diagnostic [Automatic Transaxle Aw6A-El)) >> PID/DATA MONITOR AND RECORD function table

PID/DATA MONITOR AND RECORD function table

WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
PID/DATA MONITOR AND RECORD FUNCTION

Monitor item (Definition) Unit/Condition Condition/Specification Action TCM terminal
BOO TCM (Brake switch) On/Off
  • Brake pedal depressed: On
  • Other: Off
 Inspect the brake switch.
(See BRAKE SWITCH INSPECTION .)		 -
DTC CNT - Indicates number of DTC Check DTC.
(See DTC TABLE .)		 -
DWN SW (Down switch) On/Off
  • Down shift at M range: On
  • Other: Off
 Inspect the selector lever component.
(See SELECTOR LEVER COMPONENT INSPECTION .)		 A4
ECT TCM (ECT) °C, °F Indicates ECT Inspect the TCM.
(See TCM INSPECTION .)		 -
FDPDTC (FREEZE FRAME DATA) - Indicates code of FREEZE FRAME DATA Inspect the TCM.
(See TCM INSPECTION .)		 -
GEAR_RA (Gear ratio) -
  • 1GR: 4.148
  • 2GR: 2.370
  • 3GR: 1.555
  • 4GR: 1.154
  • 5GR: 0.859
  • 6GR: 0.685
 Inspect following PIDs: THOP, TSS, VSS -
GEAR_SEL (Calculated gear range in TCM) 1st/2nd/3rd/4th/5th/6th
  • 1GR: 1st
  • 2GR: 2nd
  • 3GR: 3rd
  • 4GR: 4th
  • 5GR: 5th
  • 6GR: 6th
 Inspect following PIDs: THOP, TSS, VSS -
LPS (Pressure control solenoid) A 100-1,000 mA  Inspect the pressure control solenoid.
(See SOLENOID VALVE INSPECTION .)		 B1, B3
MNL SW (M range switch) On/Off
  • M range: On
  • Other: Off
 Inspect the selector lever component.
(See SELECTOR LEVER COMPONENT INSPECTION .)		 A7
OSS (Output shaft speed) RPM
  • Ignition switch ON: 0 rpm 
  • Indicates output shaft speed
 Inspect the VSS.
(See VEHICLE SPEED SENSOR (VSS) INSPECTION .)		 B19, B20
PNP_TCM (Park/Neutral) Drive/Neutral
  • P, N position: Neutral
  • D, M range or R position: Drive
 Inspect the TR switch.
(See TCM INSPECTION .)		 -
RPM TCM (Engine speed) RPM
  • Ignition switch ON: 0 rpm 
  • Idle: 700-800 rpm 
 Inspect the TCM.
(See TCM INSPECTION .)		 -
SSC (Shift solenoid C) A
  • P, R, N position or D/M range (5GR, 6GR): solenoid on
  • Other: solenoid off
    • 100-1,000 mA 
 Inspect the shift solenoid C.
(See SOLENOID VALVE INSPECTION .)		 B10, B11
SSD (Shift solenoid D) A
  • P, R, N position or D/M range (1GR, 2GR, 3GR): solenoid on
  • Other: solenoid off
    • 100-1,000 mA 
 Inspect the shift solenoid D.
(See SOLENOID VALVE INSPECTION .)		 B17, B18
SSE (Shift solenoid E) A
  • R position (more than 11 km/h {4 mph}) or D/M range (1GR, 2GR, 4GR, 6GR): solenoid on
  • Other: solenoid off
    • 100-1,000 mA 
 Inspect the shift solenoid E.
(See SOLENOID VALVE INSPECTION .)		 B14, B22
SSF (Shift solenoid F) A
  • P, R, N position or D/M range (1GR, 3GR, 4GR, 5GR): solenoid on
  • Other: solenoid off
    • 100-1,000 mA 
 Inspect the shift solenoid F.
(See SOLENOID VALVE INSPECTION .)		 B16, B21
TCCC (TCC solenoid valve) A
  • TCC on: solenoid on
  • Other: solenoid off
    • 200-1,000 mA 
 Inspect the TCC control solenoid.
(See SOLENOID VALVE INSPECTION .)		 B4, B9
TFT (ATF temperature) °C, °F Indicates ATF temperature Inspect the TFT sensor.
(See TRANSAXLE FLUID TEMPERATURE (TFT) SENSOR INSPECTION .)		 B7, B8
TFTV (ATF temperature signal voltage) V
  • ATF temperature 10 °C {50 °F}:

    4.78-4.81 V 

  • ATF temperature 25 °C {77 °F}:

    4.61-4.65 V 

  • ATF temperature 110 °C {230 °F}:

    2.30-2.45 V 

 Inspect the TFT sensor.
(See TRANSAXLE FLUID TEMPERATURE (TFT) SENSOR INSPECTION .)		 B7, B8
THOP (Throttle position) %
  • CTP: 0%
  • WOT: 100%
 Inspect the TP sensor.
(See THROTTLE POSITION (TP) SENSOR INSPECTION .)		 -
TR (TR switch) R/N/D/P
  • R position: R
  • N position: N
  • D range: D
  • P position: P
 Inspect the TR switch.
(See TCM INSPECTION .)		 -
TRD (TR switch [D range]) On/Off
  • D range: On
  • Other ranges and all positions: Off
 Inspect the TR switch.
(See TCM INSPECTION .)		 -
TRR (TR switch [R position]) On/Off
  • R position: On
  • Other positions and all ranges: Off
 Inspect the TR switch.
(See TCM INSPECTION .)		 -
TSS (Input/turbine speed sensor) RPM
  • Ignition switch ON: 0 rpm 
  • Idle: 700-800 rpm 
 Inspect the input/turbine speed sensor.
(See INPUT/TURBINE SPEED SENSOR INSPECTION .)		 -
UP SW (Up switch) On/Off
  • Up shift at M range: On
  • Other: Off
 Inspect the selector lever component.
(See SELECTOR LEVER COMPONENT INSPECTION .)		 A3
VSS (Vehicle speed) KPH, MPH Indicates vehicle speed Inspect the VSS.
(See VEHICLE SPEED SENSOR (VSS) INSPECTION .)		 -
scientia non olet · About LEMON Manuals