LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 247 (Seat Belt System) >> Rear Seat Belt Removal/Installation

Rear Seat Belt Removal/Installation

WARNING: This page is about a different car, the 2004 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • The ELR (emergency locking retractor) has a spring that will unwind if the retractor cover is removed. The spring cannot be rewound by hand. If this occurs, the ELR will not work properly. Therefore, do not disassemble the retractor.
  1. Remove the rear seat. (See REAR SEAT REMOVAL/INSTALLATION .)
  2. Remove the front console. (See CONSOLE REMOVAL/INSTALLATION .)
  3. Remove the rear console. (See CONSOLE REMOVAL/INSTALLATION .)
  4. Remove the rear package trim. (See REAR PACKAGE TRIM REMOVAL/INSTALLATION .)
  5. Remove in the order indicated in illustration. See Fig 1.
    Fig 1: Removing Order Of Rear Seat Belt
    G01346292Courtesy of MAZDA MOTORS CORP.
    Fig 2: Removing/Installing Rear Seat Belt
    G01346293Courtesy of MAZDA MOTORS CORP.
  6. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals