LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 241 (Interior Trim) >> Rear Package Trim Removal/Installation

Rear Package Trim Removal/Installation

WARNING: This page is about a different car, the 2004 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the following parts:
    1. Rear seat (See REAR SEAT REMOVAL/INSTALLATION .)
    2. Inner scuff plate (See INNER SCUFF PLATE REMOVAL/INSTALLATION .)
    3. Tire house trim (See TIRE HOUSE TRIM REMOVAL/INSTALLATION .)
    4. Rear pillar trim (See REAR PILLAR TRIM REMOVAL/INSTALLATION .)
  2. Remove the rear package side trim fasteners.
  3. Pull the rear package side trim upward and detach clips A from the body.
  4. Detach tabs B and pin C from the rear package center trim.
  5. Detach tabs D from the body and remove the rear package side trim.
    Fig 1: Removing/Installing Rear Package Side Trim
    G01344516Courtesy of MAZDA MOTORS CORP.
  6. Pull the rear package center trim upward and detach clips A, tabs E, and locator pin F from the body.
  7. Detach tabs D from the body and remove the rear package center trim.
  8. Install in the reverse order of removal.
    Fig 2: Removing Rear Package Center Trim
    G01344517Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals