LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2002 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 235 (Automatic Transaxle - Overhaul [Ja5EL]) >> Automatic Transaxle Assembly >> Precaution >> General Notes

General Notes

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2006 Mazda MPV, 2005 Mazda MPV, 2004 Mazda MPV, 2004 Mazda 6, and 2003 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Select the adjustment shims, referring to BEARING PRELOAD  and REDUCTION GEAR BEARING PRELOAD  .
  2. If the drive plates or 2-4 brake band are replaced with new ones, soak the new part in ATF for at least two hours before installation.
  3. Before assembly, apply ATF to all seal rings, rotating parts, O-rings, and sliding parts.
  4. All O-rings, seals, and gaskets must be replaced with the new ones included in the overhaul kit.
  5. Use petroleum jelly, not grease, when assembling again.
  6. When it is necessary to replace a bushing, replace the subcomponent that includes the bushing.
  7. Assemble the housing within 10 minutes after applying sealant, and allow it to cure for at least 30 minutes after assembly before filling the transaxle with ATF.
scientia non olet · About LEMON Manuals