Oil Cooler Removal/Installation: Notes
WARNING: This page is about a different car, the 2004 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery cable.
- Drain the ATF into a container. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT .)
- Remove the radiator. (See RADIATOR REMOVAL/INSTALLATION .)
- Remove in the order indicated in the table.
- Install in the reverse order of removal.
- Add ATF to the specified level. (See AUTOMATIC TRANSAXLE FLUID (ATF) REPLACEMENT .)
- Connect the negative battery cable.
- Inspect for oil leakage from the oil pipes and oil hoses.
- Inspect for coolant from the hoses.
- Inspect the ATF level and condition. (See AUTOMATIC TRANSAXLE FLUID (ATF) INSPECTION .)
- Carry out the line pressure test. (See MECHANICAL SYSTEM TEST .)
- Carry out the road test. (See ROAD TEST .)