Automatic Transaxle Fluid (ATF) Replacement
WARNING: This page is about a different car, the 2004 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- A hot transaxle and ATF can cause severe burns. Turn off the engine and wait until they are cool before changing the ATF.
- Remove the oil dipstick.
- Remove the oil drain plug and washer.
- Drain the ATF into a container.
- Install a new washer and the drain plug.
Tightening torque
29.4-41.2 N.m
(3.0-4.2 kgf.m, 21.7-30.3 ft.lb)
- Add the specified ATF until ATF level reaches lower notch of dipstick type of ATF through the oil filler tube.
ATF type
ATF M-V
Capacity (Approximate quantity)
7.2 L (7.6 US qt, 6.3 Imp qt)
- Ensure that the ATF level is in the HOT range (65 °C (149 °F)).
- Add ATF to the specified level as necessary.