Removal & Installation (MX-6, 626 & 929)

1. Raise and support front of vehicle. Remove front wheel assemblies. Remove lower lock pin/guide bolt. See Figure , Figure , Fig 1 or Fig 2 . Pivot caliper upward and support using rope. Remove pads, shims and guide plates. Replace pad if lining thickness is less than specified. See MINIMUM PAD LINING SPECIFICATIONS (FRONT)  .
2. To install, reverse removal procedure. Use Disc Brake Expand Tool (49-0221-600C) and an old pad to push piston fully inward to install disc pads.

Fig 1: Front Brake Disc Assembly (MX-6 & 626)

Courtesy of MAZDA MOTORS CORP.

Fig 2: Front Disc Brake Assembly (929)

Courtesy of MAZDA MOTORS CORP.