LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 1988 >> 929 Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Diagnosis - N4A-El/Hl & NC4A-El) >> Self-Diagnosis (1994 MIATA Only) >> Retrieving Fault Codes >> HOLD Indicator Light Procedure

HOLD Indicator Light Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 1994 Mazda MX-5 Miata, 1992 Mazda MX-5 Miata, 1992 Mazda MPV, 1992 Mazda B2200, and 1991 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Locate Data Link Connector (DLC) underhood on left fenderwell. Short together GND and TAT terminals of DLC and turn ignition on. See Fig 1 . Warning codes are flashed on HOLD indicator light on dash. Codes are flashed in numerical order if more than one code is present.
  2. Note fault code numbers. See FAULT CODE table. Perform appropriate diagnostic code chart. See appropriate CODE CHARTS  . After repairs are made, clear codes.
Fig 1: Locating DLC GND & TAT Terminals
G95D20563Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals