Pinpoint Test O: The FCIM (Front Controls Interface Module) Illumination Is Inoperative Or Does Not Dim
- Refer to AUDIO SYSTEM/NAVIGATION - SYNC
for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Instrument Panel and Interior Switches Illumination - System Operation and Component Description .
Possible Sources
- Communication network concern
- Wiring, terminals or connectors
- FCIM
- O1 PERFORM A NETWORK TEST
- Ignition ON.
- Using a diagnostic scan tool, perform a network test.
Does the FCIM pass the network test?
Yes GO to O2 No DIAGNOSE a concern with the network. REFER to: Communications Network . - O2 CHECK FOR CORRECT FCIM (FRONT CONTROLS INTERFACE MODULE) OPERATION
- Disconnect and inspect all FCIM and related in-line connectors.
- Repair:
- corrosion (install new connector or terminals - clean module pins)
- damaged or bent pins - install new terminals/pins
- pushed-out pins - install new pins as necessary
- Reconnect the FCIM and related in-line connectors and all previously disconnected illumination system connectors. Make sure all connectors seat and latch correctly.
- Operate the system to determine if the concern is still present.
Is the concern still present?
Yes CHECK OASIS for any applicable service articles: TSB, GSB, SSM or FSA. If a service article exists for this concern, DISCONTINUE this test and FOLLOW the service article instructions. If no service articles address this concern,, INSTALL a new INSTALL a new FCIM. Refer to the appropriate Information and Entertainment System article. No The system is operating correctly at this time. The concern may have been caused by module connections. ADDRESS the root cause of any connector or pin issues.