Normal Operation and Fault Conditions
WARNING: This page is about a different car, the 2020 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.
During new module installation, configuration files are loaded into the new module being replaced. If a discrepancy is detected between the modules or an incomplete programming procedure is carried out, a DTC sets.
PPT Z ABS MODULE DTC FAULT TRIGGER CONDITIONS
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| P05D3-57 | Driver Mode Select Switch "A" Range/Performance: Invalid/Incompatible Software Component | This DTC sets due to incomplete or improper module programming procedures. The module must be reconfigured using as-built data. |
| U2017:93 | Control Module Software 2: No Operation | This DTC sets if the RSC control logic cannot initialize after stable driving conditions are detected. This is usually due to an incomplete or improper module programming procedures. |
| U2100:46 | Initial Configuration Not Complete: Calibration/Parameter Memory Failure | This DTC is pre-set in a new ABS module and clears automatically when the ABS module is configured correctly. This DTC also sets due to incomplete or improper module programming procedures. |
| U2100:51 | Initial Configuration Not Complete: Not Programmed | This DTC is pre-set in a new ABS module and clears automatically when the ABS module is configured correctly. This DTC also sets due to incomplete or improper module programming procedures. |
| U2100:56 | Initial Configuration Not Complete: Invalid/Incompatible Configuration | This DTC sets due to incomplete or improper module programming procedures. |
| U2100:57 | Initial Configuration Not Complete: Invalid/Incompatible Software Component | This DTC is pre-set in a new ABS module and clears automatically when the ABS module is configured correctly. This DTC also sets due to incomplete or improper module programming procedures. |
| U2101:55 | Control Module Configuration Incompatible: Not Configured | This DTC sets due to incomplete or improper module programming procedures. |
| U2101:56 | Control Module Configuration Incompatible: Invalid/Incompatible Configuration | This DTC sets due to incomplete or improper module programming procedures. |
| U2101:57 | Control Module Configuration Incompatible: Invalid/Incompatible Software Component | This DTC sets due to incomplete or improper module programming procedures. |
| U2200:00 | Control Module Configuration Memory Corrupt: No Sub Type Information | This DTC sets due to incomplete or improper module programming procedures. |
| U2200:83 | Control Module Configuration Memory Corrupt: Value of Signal Protection Calculation Incorrect | This DTC sets due to incomplete or improper module programming procedures. |