Section 1031 (Abs Guided Routine - Pinpoint Tests Cp - ZA)
WARNING: This page is about a different car, the 2020 Lincoln Navigator. However, it is still accessible from the selected car via links, so may be relevant.
- Pinpoint Tests CP: EBB Brake Booster Motor Faults
- Pinpoint Tests CQ: Driver Door Status Correlation Fault
- Pinpoint Tests CR: Hydraulic Brake Booster Flow Switch Stuck On or Off
- Pinpoint Tests CS: HydroMax Brake Booster Motor Faults
- Pinpoint Tests CT: ABS Module DTC C1A99 - Pressure Sensor
- Pinpoint Tests CU: Hydraulic Brake Booster R Line: Circuit Open
- Pinpoint Tests D: ABS Module Communication Concern With BCM
- Pinpoint Tests E: The Traction Control System Is Inoperative Or Cannot Be Disabled Using The Message Center
- Pinpoint Tests F: ABS Module High Voltage Concern
- Pinpoint Tests G: Stability Control Sensor Signal Failure Faults
- Pinpoint Tests H: Hydraulic Pump Faults
- Pinpoint Tests I: ABS Module Communication Concern With TCM
- Pinpoint Tests J: ABS Module Communication Concern With SASM
- Pinpoint Tests K: SASM Battery Voltage Signal Compare Concern
- Pinpoint Tests L: SASM Signal Failure Faults
- Pinpoint Tests LA: Steering Wheel Position Sensor Signal Fault
- Pinpoint Tests LB: Steering Wheel Position Sensor Faults
- Pinpoint Tests M: Front Wheel Speed Sensor Electrical Faults
- Pinpoint Tests N: Rear Wheel Speed Sensor Electrical Faults
- Pinpoint Tests O: The Traction Control System Is Inoperative Or Cannot Be Disabled Using The Traction Control Switch
- Pinpoint Tests OA: The Hill Descent Control System Is Inoperative Or Cannot Be Disabled
- Pinpoint Tests OB: The Selectable Drive Mode Feature Is Inoperative
- Pinpoint Tests OC: The Snow/Sand Mode Feature Is Inoperative, Cannot Be Disabled Or Enabled
- Pinpoint Tests P: SASM Incompatibility Concern
- Pinpoint Tests Q: ABS Module Communication Concern With TCM
- Pinpoint Tests QA: ABS Module Communication Concern With The TCCM
- Pinpoint Tests R: ABS Module Communication Concern With CCM
- Pinpoint Tests S: ABS Module Communication Concern With TBC
- Pinpoint Tests T: SASM Communication Concern With BCM
- Pinpoint Tests X: ABS Temperature Too High
- Pinpoint Tests Y: ABS Module Internal Fault Concern
- Pinpoint Tests Z: Module Configuration Concern
- Pinpoint Tests ZA: Tire Diameter