Pinpoint Test B: Poor Image Quality - Rear Parking Aid Camera: Notes
Refer to Parking Aid for schematic and connector information.
Normal Operation and Fault Conditions
REFER to: Parking Aid - System Operation and Component Description .
Possible Causes
- Fuse
- Dirty or scratched camera lens
- Wiring, terminals or connectors
- Rear parking aid camera
- APIM
- Interference from other sources
- Low voltage Direct Current/Direct Current (DC/DC) converter module (also known as the Voltage Quality Module (VQM)) concern, if equipped
Visual Inspection and Diagnostic Pre-Checks
- Make sure the rear video camera lens is clear of any debris.
- BJB fuse 23 (15A).
NOTE:
Before disconnecting the parking aid camera or jumper harness, verify that the connectors are properly seated and latched.