Pinpoint Test A: The Rear Parking Aid Camera Is Inoperative - Vehicles With Rear Only Parking Aid Camera: Notes

NOTE: To identify the SYNC generation, Refer to the appropriate Information and Entertainment Systems article for the procedure.

Refer to Parking Aid for schematic and connector information.

Normal Operation and Fault Conditions

BCM DTC Fault Trigger Conditions

DTC	Description	Fault Trigger Conditions
B115E:01	Camera Module: General Electrical Failure	A continuous and on-demand DTC that sets in the BCM when an internal electrical failure is detected from the camera.
B115E:02	Camera Module: General Signal Failure	A continuous and on-demand DTC that sets in the BCM when invalid LIN data is received from the video camera.
B115E:08	Camera Module: Bus Signal/Message Failure	A continuous and on-demand DTC that sets in the BCM when there is a LIN communication fault from the video camera.

APIM DTC Fault Trigger Conditions

DTC	Description	Fault Trigger Conditions
C1001:01	Vision System Camera: General Electrical Failure	A continuous and on-demand DTC that sets in the APIM when no video signal is detected from the rear parking aid camera with the vehicle in REVERSE.

Possible Causes

Fuse
Wiring, terminals or connectors
Communication network concern
Rear parking aid camera
TR input concern
Infotainment display concern
LIN concern
BCM
APIM
Low voltage Direct Current/Direct Current (DC/DC) converter module (also known as the Voltage Quality Module (VQM)) concern, if equipped

Visual Inspection and Diagnostic Pre-Checks

BJB fuse 23 (15A).
Verify the liftgate is fully closed.
If the rear parking aid camera is not configured after replacement, some video functions will be inoperative. Verify the rear parking aid camera configuration using the diagnostic scan tool.

NOTE: Before disconnecting the parking aid camera or jumper harness, verify that the connectors are properly seated and latched.