Pinpoint Test Q : DTC C00A3:1C: Notes
WARNING: This page is about a different variant/trim than selected.
DTC C00A3:1C
Refer to All Wheel Drive (AWD) for schematic and connector information.
Normal Operation and Fault Conditions
The RDU Motor contains a 2-wire Hall Effect position sensor (RDUPS). The AWD module sends a 5-volt reference voltage that is toggled low as the motor rotates.
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| C00A3:1C | Driveline Control Module Power Transfer Unit Control circuit driver: Circuit Voltage Out of Range | The AWD Module detected Reference voltage outside of 4.7v-5.29v. (AWD Connector pin 35). |
Possible Causes
- Fuse
- Wiring, terminals or connectors
- RDU position sensor (part of RDU)
- AWD module