Pinpoint Test N : C0099:14, C0099:16, C0099:17, C009A:14, C009A:17, C009B:14, C009B:16, C009B:17 And C009C: Notes
WARNING: This page is about a different variant/trim than selected.
Refer to All Wheel Drive (AWD) for schematic and connector information.
Normal Operation and Fault Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| C0099:14 | 4WD/AWD Rear Differential Unit Actuator "A" Position Sensor "A": Circuit Short To Ground Or Open | This DTC sets if the AWD module detects a short to ground or an open the A position sensor circuit. |
| C0099:16 | 4WD/AWD Rear Differential Unit Actuator "A" Position Sensor "A": Circuit Voltage Below Threshold | This DTC sets if the AWD module detects low voltage in the A position sensor circuit. |
| C0099:17 | 4WD/AWD Rear Differential Unit Actuator "A" Position Sensor "A": Circuit Voltage Above Threshold | This DTC sets if the AWD module detects high voltage in the A position sensor circuit. |
| C009A:14 | 4WD/AWD Rear Differential Unit Actuator "A" Position Sensor "B": Circuit Short To Ground or Open | This DTC sets if the AWD module detects a short to ground or an open the B position sensor circuit. |
| C009A:16 | 4WD/AWD Rear Differential Unit Actuator "A" Position Sensor "B": Circuit Voltage Below Threshold | This DTC sets if the AWD module detects low voltage in the B position sensor circuit. |
| C009A:17 | 4WD/AWD Rear Differential Unit Actuator "A" Position Sensor "B": Circuit Voltage Above Threshold | This DTC sets if the AWD module detects high voltage in the B position sensor circuit. |
| C009B:14 | 4WD/AWD Rear Differential Unit Actuator "A" Position Sensor "C": Circuit Short To Ground Or Open | This DTC sets if the AWD module detects a short to ground or an open the C position sensor circuit. |
| C009B:16 | 4WD/AWD Rear Differential Unit Actuator "A" Position Sensor "C": Circuit Voltage Below Threshold | This DTC sets if the AWD module detects low voltage in the C position sensor circuit. |
| C009B:17 | 4WD/AWD Rear Differential Unit Actuator "A" Position Sensor "C": Circuit Voltage Above Threshold | This DTC sets if the AWD module detects high voltage in the C position sensor circuit. |
Possible Causes
- Connectors damaged or pushed-out terminals, corrosion, loose wires and missing or damaged seals
- RDU motor sensor
- AWD module