Pinpoint Test E : DTCS P0603:00, P060A:00, P060C:00 And P1397:00: Notes
WARNING: This page is about a different variant/trim than selected.
Refer to All Wheel Drive (AWD) for schematic and connector information.
Normal Operation and Fault Conditions
If the AWD Module observes an overpower or a low voltage condition, a DTC is set.
DTC Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| P0603:00 | Internal Control Module Keep Alive Memory (KAM) Error | The AWD module detected an internal fault which may have been caused by a voltage supply concern to the module. INSTALL a new AWD Module. REFER to: All-Wheel Drive (AWD) Module . |
| P060A:00 | Internal Control Module Monitoring Processor Performance | INSTALL a new AWD Module. REFER to: All-Wheel Drive (AWD) Module . |
| P060C:00 | Internal Control Module Main Processor Performance | INSTALL a new AWD Module. REFER to: All-Wheel Drive (AWD) Module . |
| P1397:00 | System Voltage Out Of Self Test Range | CLEAR the DTC. Turn the ignition off. Wait 1 minute. Ignition ON. RETRIEVE Continuous memory DTCs from all modules. |