Pinpoint Test C : DTCS C0092:17, C0092:32, C0092:33 And C0092:38: Notes

WARNING: This page is about a different variant/trim than selected.

Refer to All Wheel Drive (AWD) for schematic and connector information.

Normal Operation and Fault Conditions

If the AWD Module observes an overpower or a low voltage condition, a DTC is set and all PTU outputs are turned off.

DTC Fault Trigger Conditions

DTC	Description	Fault Trigger Conditions
C0092:17	4WD/AWD Power Transfer Unit Position Sensor "B" Circuit Voltage Above Threshold	PTU fork position signal voltage above threshold.
C0092:32	4WD/AWD Power Transfer Unit Position Sensor "B" Signal Low Time < Minimum	PTU fork position sensor signal out of range. PTU Cam position sensor signal < 3% DC.
C0092:33	4WD/AWD Power Transfer Unit Position Sensor "B" Signal Low Time > Maximum	PTU fork position sensor signal out of range. PTU Cam position sensor signal > 90% DC.
C0092:38	4WD/AWD Power Transfer Unit Position Sensor "B" Signal Frequency Incorrect	PTU fork position sensor frequency out of range. PTU Cam position sensor frequency out of range 1kHz +/- 150Hz.

Possible Sources