LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2019 >> MKC Select, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Electronic Engine Controls - 2.3L ECOBOOST (201KW/273PS)) >> Removal And Installation >> Fuel Rail Pressure (FRP) Sensor >> Removal

Fuel Rail Pressure (FRP) Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Refer to: Fuel System Pressure Release 2.3L EcoBoost .
  2. Refer to: Battery Disconnect and Connect .
  3. NOTE: Do not pull the engine appearance cover forward or sideways to remove. Failure to press straight upward on the underside of the cover at the attachment points may result in damage to the cover or engine components.
    1. Place your hand under the engine appearance cover at each grommet location and push straight up to release each grommet from the studs.
    2. After all of the grommets have been released from the studs, remove the appearance cover from the engine.
GFD393487Courtesy of FORD MOTOR COMPANY
GFD394436Courtesy of FORD MOTOR COMPANY
GFD394437Courtesy of FORD MOTOR COMPANY
scientia non olet · About LEMON Manuals