Pinpoint Test E : B11DB:83: Notes
WARNING: This page is about a different car, the 2018 Ford Focus. However, it is still accessible from the selected car via links, so may be relevant.
Refer to Charging System for schematic and connector information.
Normal Operation and Fault Conditions
The BCM monitors the battery state of charge using the battery monitoring sensor attached to the negative battery cable. Battery voltage is hardwired to the battery monitoring sensor and data is transferred from the battery monitoring sensor to the BCM via a LIN circuit.
Diagnostic Trouble Code (DTC) Fault Trigger Conditions
| DTC | Description | Fault Trigger Conditions |
|---|---|---|
| B11DB:83 | Battery Monitoring Module "A": Value of Signal Protection Calculation Incorrect | This Continuous Memory Diagnostic Trouble Code (CMDTC) sets if the BCM receives corrupted data from the battery monitoring sensor over the LIN. |
Possible Sources
- Battery monitoring sensor
- Wiring, terminals or connectors
- BCM
Visual Inspection and Diagnostic Pre-checks
- Inspect battery monitoring sensor
- Inspect battery monitoring sensor connector
- Inspect BJB fuse 22 (15A)