LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2012 >> MKZ Hybrid >> Repair and Diagnosis >> Body & Frame >> Sun Roof/T-Top/Convertible Top >> Sunroof - Roof Opening Panel >> General Procedures >> Roof Opening Panel Alignment

Roof Opening Panel Alignment

  1. Open the roof opening panel to the VENT position.
  2. Loosen the 4 roof opening panel glass screws.
    • To access the glass screws, unclip the top portion of the concertina blind and position aside as shown in illustration.
    Fig 1: Location of Roof Opening Panel Glass Screws
    G06258278Courtesy of FORD MOTOR CO.
  3. Close the roof opening panel glass.
    4. NOTE: The correct position of the roof opening panel glass to the roof panel should be -1.50 mm to 0 mm (-0.059 to 0 in) at the front edge and 0 mm to 1.5 mm (0 to 0.059 in) at the rear edge of the roof panel.
    Make sure the roof opening panel is centered in the roof opening.
    Fig 2: Adjusting Roof Opening Panel Glass
    G06258279Courtesy of FORD MOTOR CO.
  4. Adjust the roof opening panel glass.
  5. Tighten the 4 roof opening panel glass screws to 6 Nm (53 lb-in).
    Fig 3: Location of Roof Opening Panel Glass Screws
    G06258278Courtesy of FORD MOTOR CO.
  6. Open the roof opening panel to the VENT position.
  7. Reattach the concertina blind making sure that it is fully seated on the 3 clips in the roof panel glass.
Fig 4: Location of Roof Panel Glass Clips
G06271608Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals