LEMON Manuals: Even more car manuals for everyone
Home >> Lincoln >> 2012 >> MKZ Hybrid >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Handles, Locks, Latches And Entry Systems >> Diagnosis And Testing >> Handles, Locks, Latches and Entry Systems >> Pinpoint Tests >> Pinpoint Test AA: DTCs B106E, B106F >> PINPOINT TEST AA: DTCs B106E, B106F

PINPOINT TEST AA: DTCs B106E, B106F

NOTE: If DTC B106F is present and the DDM is to be replaced, the fault condition must be corrected first. Failure to correct the fault condition first may cause damage to the new DDM, resulting in a repeat repair.
  1. AA1 REVIEW THE DTCs 
    • Review the DTCs from the DDM self-test.
    • Is only DTC B106F present? 
      • Yes:  INSTALL a new DDM. REFER to Driver Door Module (DDM)  . TEST the system for normal operation.
      • No:  CORRECT any DTCs present other than DTC B106E (DTC B106F may also be present). REFER to DTC Charts  . After the repair, GO to  AA2.
  2. AA2 CARRY OUT THE DDM SELF-TEST 
    • Carry out the DDM self-test.
    • Is only DTC B106F present? 
      • Yes:  INSTALL a new DDM. REFER to Driver Door Module (DDM)  . TEST the system for normal operation.
      • No:  The system is operating correctly at this time. The concern was caused by a fault in one of the output circuits, which is no longer present.
scientia non olet · About LEMON Manuals