Air Bag Warning
- Instrument cluster monitors a ground signal from air bag diagnostic module to indicate a fault in air bag system.
- Turn ignition on. Ensure air bag warning display comes on, momentarily turns off and returns to normal operation. This is prove-out mode, and ensures all segments are operating properly.
- Air bag module is located behind instrument panel, near right side of steering wheel, above warning chime module. Air bag module contains two 12-pin wiring connectors. With ignition off, disconnect connector containing Black/Yellow wire from air bag module.NOTE: Connector containing Black/Yellow wire uses all connector pins; other connector does not use 2 pins.
- Turn ignition on. Ensure warning is not displayed. Connect jumper wire between circuit No. 608 (Black/Yellow wire) of air bag module connector and ground. Warning should be displayed. If warning does not display, check Black/Yellow wire between air bag module and instrument cluster connector C1, pin No. 12 for open circuit. See Figure and Figure .