Installation [11/2021 - ]: Procedure

WARNING: Be sure to wear insulated gloves. NOTE: Do not allow foreign matter, such as grease or oil, to adhere to the bolts of the HV battery. To prevent the wire harness from being caught, make sure to bundle the wire harness using insulating tape or equivalent. Use cardboard or another similar material to protect the HV battery and vehicle body from damage. Since the HV battery is very heavy, 2 people are needed to install it. When installing the HV battery, be careful not to damage the parts around it. When removing/installing/moving the HV battery, make sure not to tilt it more than 80°. While lowering the HV battery into the vehicle, do not allow it to contact the vehicle. As bolts with 2 different lengths are used, make sure to install each bolt to the correct position. If the HV battery has been struck or dropped, replace it.

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Bolt (A) (Bolt Length: 25 mm (0.984 in.))

   *b

   Bolt (B) (Bolt Length: 24 mm (0.945 in.))

   Torque: 19 N*m (194 kgf*cm, 14 ft.*lbf) 

WARNING: Be sure to wear insulated gloves.

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	Battery Cover Lock Striker	-	-
   *a	Button	*b	Push

   1. Install the No. 1 HV battery cover panel RH to the HV battery with the 3 bolts and 3 nuts.

      Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf) 

   2. Install the battery cover lock striker, then push the button to lock it.

Refer to PROCEDURE - Step 2

Refer to PROCEDURE - Step 1

Refer to WORK PROCEDURE [11/2021 - 03/2023] , or refer to WORK PROCEDURE [03/2023 - 03/2024] , or refer to WORK PROCEDURE [03/2024 - ]