Installation [11/2021 - ]: Procedure

Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf) 

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   1. Install the battery cooling blower assembly to the HV battery with the 2 bolts.

      Torque: 7.5 N*m (76 kgf*cm, 66 in.*lbf) 

      NOTE:

      • Be sure not to touch the fan part of the battery cooling blower assembly.
      • Do not lift the battery cooling blower assembly using the wire harness.
   2. Connect the battery cooling blower assembly connector.

1. Fig 1: Rear Seat Cushion Leg Sub-Assembly Bolts Tightening Sequence

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   1. Temporarily install the rear seat cushion leg sub-assembly with the 6 bolts.
   2. Fully tighten the 6 bolts in the order shown in the illustration.

      Torque: 19.5 N*m (199 kgf*cm, 14 ft.*lbf)