LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2025 >> NX 350h >> Repair and Diagnosis >> External Pages >> Different car >> Section 74 (Fuel System - Service Information) >> FUEL PUMP (for High Pressure) >> On-Vehicle Inspection [11/2021 - ] >> Procedure

On-Vehicle Inspection [11/2021 - ]: Procedure

WARNING: This page is about a different car, the 2025 Lexus NX 250, 2024 Lexus NX 250, 2023 Lexus NX 250, and 2022 Lexus NX 250. However, it is still accessible from the selected car via links, so may be relevant.
  1. FUEL (ENGINE ROOM SIDE) PUMP ASSEMBLY OPERATION 
    1. Check fuel pressure.
      1. Start the engine.
      2. Check that the fuel pressure fluctuates when the target fuel pressure changes.

        Powertrain > Engine > Active Test 

        Active Test Display
        Control the Target Fuel Pressure Offset
        Data List Display
        Fuel Pressure (High)

        HINT: 

        The target fuel pressure operation decreases the target fuel pressure by 12.5% or increases the target fuel pressure by 24.8%.

        If the result is not as specified, replace the fuel (engine room side) pump assembly or fuel pressure sensor.

    2. Check operating sound.
      1. Remove the No. 1 engine cover sub-assembly.

        Refer to PROCEDURE - Step 23 [11/2021 - 03/2024] , or refer to PROCEDURE - Step 23 [03/2024 - ]

      2. Start the engine.
      3. Using a sound scope, check the operating sound of the fuel (engine room side) pump assembly.

        If no sound can be heard, check the fuel (engine room side) pump assembly, wire harness and ECM.

      4. Stop the engine.
      5. Install the No. 1 engine cover sub-assembly.

        Refer to PROCEDURE - Step 48

scientia non olet · About LEMON Manuals