Replacement [11/2021 - 03/2024]: Procedure
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2025 Lexus NX 350, 2025 Lexus NX 250, 2024 Lexus NX 350, 2024 Lexus NX 250, and 2023 Lexus NX 350. However, it is still accessible from the selected car via links, so may be relevant.
- REMOVE FRONT DRIVE SHAFT ASSEMBLY RH
- for A25A-FKS:
Refer to REMOVAL [11/2021 - 03/2024]
- for T24A-FTS:
Refer to REMOVAL [11/2021 - 03/2024]
- for A25A-FKS:
- REMOVE DRIVE SHAFT BEARING BRACKET
- for A25A-FKS:
Refer to PROCEDURE - Step 1 [11/2021 - 03/2022] , or refer to PROCEDURE - Step 1 [03/2022 - 03/2024]
- for T24A-FTS:
Refer to PROCEDURE - Step 1
- for A25A-FKS:
- REMOVE TRANSFER CASE OIL SEAL RH
- INSTALL TRANSFER CASE OIL SEAL RH
- Coat the lip of a new transfer case oil seal RH with MP grease.
- Using SST and a hammer, tap in the transfer case oil seal RH to the transfer assembly as shown in the illustration.
*1 Transfer Case Oil Seal RH - SST: 09631-32020
- SST: 09950-60021
- 09951-00680
- SST: 09950-70010
- 09951-07360
Drive in Depth (A)
7.5 to 8.5 mm (0.296 to 0.334 in.)
NOTE:- Tap the transfer case oil seal RH uniformly so that the transfer case oil seal RH is straight.
- Do not tap the transfer case oil seal RH in too far.
- INSTALL DRIVE SHAFT BEARING BRACKET
- for A25A-FKS:
Refer to PROCEDURE - Step 63 [11/2021 - 03/2022] , or refer to PROCEDURE - Step 63 [03/2022 - ]
- for T24A-FTS:
Refer to PROCEDURE - Step 55
- for A25A-FKS:
- INSTALL FRONT DRIVE SHAFT ASSEMBLY RH
- for A25A-FKS:
Refer to INSTALLATION [11/2021 - ]
- for T24A-FTS:
Refer to INSTALLATION [11/2021 - ]
- for A25A-FKS: