Replacement [11/2021 - ]: Procedure

WARNING: This page is about a different car, the 2025 Lexus NX 250, 2024 Lexus NX 250, 2023 Lexus NX 250, and 2022 Lexus NX 250. However, it is still accessible from the selected car via links, so may be relevant.

REMOVE FRONT FENDER FRONT SPLASH SHIELD LH
Refer to PROCEDURE - Step 8 [11/2021 - 03/2024] , or refer to PROCEDURE - Step 8 [03/2024 - ]
REMOVE FRONT FENDER FRONT SPLASH SHIELD RH
Refer to PROCEDURE - Step 9 [11/2021 - 03/2024] , or refer to PROCEDURE - Step 9 [03/2024 - ]
REMOVE NO. 1 ENGINE UNDER COVER
Refer to PROCEDURE - Step 10 [11/2021 - 03/2024] , or refer to PROCEDURE - Step 10 [03/2024 - ]
REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 11 [11/2021 - 03/2024] , or refer to PROCEDURE - Step 11 [03/2024 - ]
REMOVE FRONT FENDER APRON SEAL LH
Refer to PROCEDURE - Step 12 [11/2021 - 03/2024] , or refer to PROCEDURE - Step 12 [03/2024 - ]
REPLACE AUTOMATIC TRANSAXLE FLUID
Refer to PROCEDURE - Step 6
ADD SPECIFIED AMOUNT OF AUTOMATIC TRANSAXLE FLUID
See step 5
ADJUST AUTOMATIC TRANSAXLE FLUID TEMPERATURE (when Using the GTS)
See step 6
ADJUST AUTOMATIC TRANSAXLE FLUID TEMPERATURE (when Not Using the GTS)
See step 7
ADJUST AUTOMATIC TRANSAXLE FLUID LEVEL
See step 8
PERFORM ATF THERMAL DEGRADATION ESTIMATE RESET
NOTE:
If approximately 50% or more of the ATF has been replaced during a repair of the transaxle or a similar operation, perform ATF Thermal Degradation Estimate Reset.

Refer to INITIALIZATION [11/2021 - ]
REBUILD WORK
See step 9
INSTALL FRONT FENDER APRON SEAL LH
Refer to PROCEDURE - Step 70
INSTALL NO. 2 ENGINE UNDER COVER ASSEMBLY
Refer to PROCEDURE - Step 72
INSTALL NO. 1 ENGINE UNDER COVER
Refer to PROCEDURE - Step 73
INSTALL FRONT FENDER FRONT SPLASH SHIELD RH
Refer to PROCEDURE - Step 75
INSTALL FRONT FENDER FRONT SPLASH SHIELD LH
Refer to PROCEDURE - Step 74