LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> TX 350 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 98 (Engine Lubrication System (2GR-FXS) - Service Information) >> Engine Oil Cooler >> Installation [12/2023 - ] >> Procedure

Installation [12/2023 - ]: Procedure

WARNING: This page is about a different car, the 2024 Lexus TX 550h+. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL OIL COOLER ASSEMBLY 

    Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf) 

  2. CONNECT NO. 5 WATER BY-PASS HOSE 
  3. CONNECT NO. 4 WATER BY-PASS HOSE 
  4. INSTALL WATER HOSE CLAMP 

    Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

  5. INSTALL EXHAUST MANIFOLD ASSEMBLY LH 

    Refer to INSTALLATION [12/2023 - ]

  6. ADD ENGINE OIL 

    Refer to PROCEDURE - Step 5

  7. ADD ENGINE COOLANT (for Engine) 

    Refer to PROCEDURE - Step 7

  8. CHECK ENGINE OIL LEVEL 

    Refer to PROCEDURE - Step 1

  9. INSPECT FOR ENGINE OIL LEAK 

    Refer to PROCEDURE - Step 6

  10. INSPECT FOR COOLANT LEAK (for Engine) 

    Refer to PROCEDURE - Step 8

scientia non olet · About LEMON Manuals