LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> TX 350 Base, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Engine Control System - Service Information) >> CAMSHAFT OIL CONTROL SOLENOID (for Bank 1) >> Removal [12/2023 - ] >> Procedure

Removal [12/2023 - ]: Procedure

WARNING: This page is about a different car, the 2024 Lexus TX 550h+. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE FRONT WHEEL RH 

    Refer to REMOVAL [09/2023 - ]

  2. REMOVE FRONT FENDER APRON SEAL RH 

    Refer to PROCEDURE - Step 13

  3. REMOVE CAM TIMING OIL CONTROL SOLENOID ASSEMBLY (for Exhaust Side of Bank 1) 
    1. GTY1228514Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Disconnect the cam timing oil control solenoid assembly connector.
      2. Remove the 2 bolts and cam timing oil control solenoid assembly from the timing chain cover assembly.
        NOTE:

        If the cam timing oil control solenoid assembly has been struck or dropped, replace it.

      3. Remove the O-ring from the cam timing oil control solenoid assembly.
        NOTE:
        • The O-ring may stick timing chain cover assembly.
        • Do not drop the O-ring inside of the timing chain cover assembly.
  4. REMOVE CAM TIMING OIL CONTROL SOLENOID ASSEMBLY (for Intake Side of Bank 1) 
    1. GTY1236314Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Disconnect the cam timing oil control solenoid assembly connector.
      2. Remove the 2 bolts and cam timing oil control solenoid assembly from the timing chain cover assembly.
        NOTE:

        If the cam timing oil control solenoid assembly has been struck or dropped, replace it.

      3. Remove the O-ring from the cam timing oil control solenoid assembly.
        NOTE:
        • The O-ring may stick timing chain cover assembly.
        • Do not drop the O-ring inside of the timing chain cover assembly.
scientia non olet · About LEMON Manuals