Installation [10/2022 - ]: Procedure

INSTALL SPARK PLUG

NOTE:

If a spark plug has been struck or dropped, replace it.

Torque: 20 N.m (204 kgf/cm, 15 ft.lbf)

INSTALL IGNITION COIL ASSEMBLY

Refer to PROCEDURE - Step 2
CONNECT ENGINE WIRE

INSTALL NO. 3 ENGINE COVER

for 1Motor-HEV Model:
Refer to PROCEDURE - Step 55
for Gasoline Model:
Refer to PROCEDURE - Step 55

INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

for 1Motor-HEV Model:
Refer to PROCEDURE - Step 56
for Gasoline Model:
Refer to PROCEDURE - Step 56

PERFORM INITIALIZATION
1. Perform "Inspection After Repair" after replacing an ignition coil assembly or spark plug.
  - for 1Motor-HEV Model:
    Refer to INITIALIZATION [10/2022 - ]
  - for Gasoline Model:
    Refer to INITIALIZATION [10/2022 - ]