LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> RX 500h >> Repair and Diagnosis >> External Pages >> Different car >> Section 74 (Engine Cooling System - Service Information) >> Thermostat >> Installation [10/2022 - 08/2023] >> Procedure

Installation [10/2022 - 08/2023]: Procedure

WARNING: This page is about a different car, the 2025 Lexus RX 450h+, 2025 Lexus RX 350h, 2024 Lexus RX 450h+, 2024 Lexus RX 350h, and 2023 Lexus RX 350h. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY 
    1. GTY1077714Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Install a new gasket to the water inlet with thermostat sub-assembly.

        HINT: 

        Be sure to clean the contact surfaces.

      2. Using an 8 mm socket wrench, install the water inlet with thermostat sub-assembly with the 2 bolts.

        Torque: 10 N.m (102 kgf/cm, 7 ft.lbf) 

  2. CONNECT NO. 7 WATER BY-PASS HOSE 
    1. GTY1078180Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a View A *b 15°
      *c 90° (Tabs of Clip Installation Area) *d Upper Side of Vehicle
      *e Front Side of Vehicle *f 1 mm (0.0394 in.) or more
      1. Connect the No. 7 water by-pass hose to the water inlet with thermostat sub-assembly and slide the clip to secure it.
        NOTE:

        Make sure that the tabs of the clip are within the area shown in the illustration.

  3. CONNECT NO. 2 RADIATOR HOSE 
    Refer to PROCEDURE - Step 38
  4. INSTALL INTAKE MANIFOLD 

    Refer to INSTALLATION [10/2022 - 08/2023]

  5. ADD ENGINE COOLANT (for Engine) 

    Refer to PROCEDURE - Step 5

  6. INSPECT FOR COOLANT LEAK (for Engine) 

    Refer to PROCEDURE - Step 1

  7. INSTALL NO. 1 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 67

  8. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH 
  9. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH 
scientia non olet · About LEMON Manuals