Installation [10/2022 - 08/2023]: Procedure

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	O-ring	-	-
   *a	Seam	*b	Camshaft Position Sensor Tip
   *c	OK	*d	NG

   1. Perform this procedure only when reusing the camshaft position sensor.

      1. Clean the O-ring groove of the camshaft position sensor.

      NOTE:

      Make sure the O-ring groove is free of foreign matter.

      2. Install a new O-ring to the camshaft position sensor.

      NOTE:

      Set the O-ring on the tip of the camshaft position sensor and roll it into the O-ring groove with bare hands to install it.

      3. Check if the O-ring is twisted.

      HINT: 

      Check the entire circumference of the seam of the O-ring for twisting.

   2. Apply a light coat of engine oil to the O-ring of the camshaft position sensor.
   3. Using an 8 mm socket wrench, install the camshaft position sensor to the cylinder head cover sub-assembly with a new bolt.

      Torque: 7.5 N.m (76 kgf/cm, 66 in.lbf) 

      NOTE:

      • If the camshaft position sensor has been struck or dropped, replace it.
      • Make sure that the O-ring is not cracked or moved out of place when installing the camshaft position sensor.
   4. Connect the camshaft position sensor connector.

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *1	O-ring	-	-
   *a	Seam	*b	Camshaft Position Sensor Tip
   *c	OK	*d	NG

   1. Perform this procedure only when reusing the camshaft position sensor.

      1. Clean the O-ring groove of the camshaft position sensor.

      NOTE:

      Make sure the O-ring groove is free of foreign matter.

      2. Install a new O-ring to the camshaft position sensor.

      NOTE:

      Set the O-ring on the tip of the camshaft position sensor and roll it into the O-ring groove with bare hands to install it.

      3. Check if the O-ring is twisted.

      HINT: 

      Check the entire circumference of the seam of the O-ring for twisting.

   2. Apply a light coat of engine oil to the O-ring of the camshaft position sensor.
   3. Using an 8 mm socket wrench, install the camshaft position sensor to the cylinder head cover sub-assembly with a new bolt.

      Torque: 7.5 N.m (76 kgf/cm, 66 in.lbf) 

      NOTE:

      • If the camshaft position sensor has been struck or dropped, replace it.
      • Make sure that the O-ring is not cracked or moved out of place when installing the camshaft position sensor.
   4. Connect the camshaft position sensor connector.

Refer to PROCEDURE - Step 6