LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> RX 500h >> Repair and Diagnosis >> Body & Frame >> Exterior Body Panels >> Door / Hatch - Service Information (2 Of 3) >> Back Door >> Reassembly [10/2022 - ] >> Procedure

Reassembly [10/2022 - ]: Procedure

  1. INSTALL NO. 1 AMPLIFIER ANTENNA ASSEMBLY 

    Refer to PROCEDURE - Step 1

  2. INSTALL NO. 5 ANTENNA CORD SUB-ASSEMBLY 
    Refer to PROCEDURE - Step 1
  3. INSTALL ROOF HEADLINING ASSEMBLY 

    Refer to INSTALLATION [10/2022 - 08/2023] , or refer to INSTALLATION [08/2023 - ]

  4. INSTALL BACK DOOR STAY STOPPER 
  5. INSTALL BACK DOOR DAMPER STAY LOWER BRACKET LH 
    Refer to PROCEDURE - Step 2
  6. INSTALL BACK DOOR DAMPER STAY LOWER BRACKET RH 
    1. Use the same procedure as for the LH side.
  7. INSTALL BACK DOOR DAMPER STAY UPPER BRACKET LH 
    Refer to PROCEDURE - Step 3
  8. INSTALL BACK DOOR DAMPER STAY UPPER BRACKET RH 
    1. Use the same procedure as for the LH side.
  9. INSTALL POWER BACK DOOR UNIT ASSEMBLY LH 
    Refer to PROCEDURE - Step 4
  10. INSTALL POWER BACK DOOR UNIT ASSEMBLY RH 
    1. Use the same procedure as for the LH side.
  11. INSTALL BACK DOOR DUST PROOF SEAL 
  12. INSTALL REAR TELEVISION CAMERA ASSEMBLY 
  13. INSTALL BACK DOOR OPENER SWITCH ASSEMBLY 
  14. INSTALL REAR LIGHT ASSEMBLY 

    Refer to PROCEDURE - Step 1

  15. INSTALL REAR WIPER MOTOR GROMMET 
    Refer to PROCEDURE - Step 1
  16. INSTALL REAR WIPER MOTOR ASSEMBLY 

    Refer to PROCEDURE - Step 2

  17. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY 
    Refer to PROCEDURE - Step 3
  18. INSTALL REAR WASHER NOZZLE 
  19. INSTALL REAR SPOILER SIDE PROTECTOR SUB-ASSEMBLY LH 
  20. INSTALL REAR SPOILER SIDE PROTECTOR SUB-ASSEMBLY RH 
  21. INSTALL REAR SPOILER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 3

  22. INSTALL HOLE PLUG 
  23. INSTALL BACK DOOR LOCK ASSEMBLY WITH COURTESY LIGHT SWITCH 
    Refer to PROCEDURE - Step 1
  24. INSTALL BACK DOOR WEIGHT 

    Torque: 8.0 N.m (82 kgf/cm, 71 in.lbf) 

  25. INSTALL MULTIPLEX NETWORK DOOR ECU 

    Refer to PROCEDURE - Step 1

  26. INSTALL INNER MIRROR CAMERA ASSEMBLY (w/ Digital Inner Mirror) 
  27. CONNECT POWER BACK DOOR UNIT ASSEMBLY LH 
  28. CONNECT POWER BACK DOOR UNIT ASSEMBLY RH 
  29. INSTALL POWER BACK DOOR SENSOR ASSEMBLY LH 
  30. INSTALL POWER BACK DOOR SENSOR ASSEMBLY RH 
  31. INSTALL BACK DOOR TRIM BOARD ASSEMBLY 
  32. INSTALL NO. 2 LUGGAGE COMPARTMENT LIGHT ASSEMBLY 
  33. INSTALL BACK DOOR SERVICE HOLE COVER 
  34. INSTALL BACK DOOR INSIDE HANDLE 
    1. GTY1126120Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *a Switch Cover - -
      Install in this Direction - -
      1. Connect the 2 connectors.
      2. Remove the release paper of the double-sided tape without touching the adhesive surface, and attach a new switch cover from the location shown in the illustration.
      3. Attach the switch cover in the direction shown in the illustration.
      4. Insert the 3 guides and engage the 3 claws to install the back door inside handle.
  35. INSTALL BACK DOOR LOCK COVER 
  36. INSTALL BACK DOOR SIDE GARNISH LH 
  37. INSTALL BACK DOOR SIDE GARNISH RH 
  38. INSTALL BACK DOOR UPPER TRIM COVER 
  39. ADJUST REAR WASHER NOZZLE 

    Refer to PROCEDURE - Step 1

  40. INITIALIZE POWER BACK DOOR SYSTEM 

    Refer to INITIALIZATION [10/2022 - ]

  41. INSPECT POWER BACK DOOR SYSTEM 
    Refer to OPERATION CHECK [10/2022 - ]
  42. PERFORM CALIBRATION 
    1. w/ Parking Assist Monitor System:

      Refer to CALIBRATION [10/2022 - ]

    2. w /Advanced Park:

      Refer to CALIBRATION [10/2022 - ]

  43. ADJUST BACK DOOR 
    HINT: 
    When the back door damper stay lower bracket is removed, it is necessary to perform back door position adjustment.
    Refer to ADJUSTMENT [10/2022 - ] 
scientia non olet · About LEMON Manuals