LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> RX 350h Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (Fuel System - Service Information (2 Of 2)) >> FUEL PUMP (for High Pressure (1Motor-HEV Model)) >> Removal [10/2022 - ] >> Procedure

Removal [10/2022 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2025 Lexus RX 500h, 2025 Lexus RX 350, 2024 Lexus RX 500h, 2024 Lexus RX 350, and 2023 Lexus RX 500h. However, it is still accessible from the selected car via links, so may be relevant.
  1. PRECAUTION 
    NOTE:

    After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.

    Refer to BEFORE DISCONNECTING BATTERY [10/2022 - ]
  2. DISCHARGE FUEL SYSTEM PRESSURE 

    Refer to PRECAUTION [10/2022 - ]

  3. REMOVE BATTERY SERVICE COVER PLATE 

    Refer to PROCEDURE - Step 2

  4. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 

    Refer to PROCEDURE - Step 3

  5. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY 
    Refer to PROCEDURE - Step 22
  6. REMOVE NO. 3 ENGINE COVER 

    Refer to PROCEDURE - Step 23

  7. REMOVE NO. 2 ENGINE COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 5

  8. DISCONNECT ENGINE WIRE 

    Refer to PROCEDURE - Step 8

  9. DISCONNECT PURGE VALVE (NO. 1 VACUUM SWITCHING VALVE ASSEMBLY) 

    Refer to PROCEDURE - Step 9

  10. REMOVE AIR TUBE ASSEMBLY 
    Refer to REMOVAL [10/2022 - ]
  11. REMOVE AIR CLEANER CAP WITH NO. 1 AIR CLEANER HOSE 

    Refer to PROCEDURE - Step 11

  12. REMOVE NO. 2 VENTILATION HOSE 

    Refer to PROCEDURE - Step 12

  13. DISCONNECT FUEL TUBE SUB-ASSEMBLY 
    1. GTY1130101Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Disconnect the fuel tube sub-assembly from the fuel (engine room side) pump assembly.

        Refer to PRECAUTION [10/2022 - ]

  14. REMOVE NO. 1 FUEL PIPE SUB-ASSEMBLY 
    WARNING:

    To prevent serious injury due to fuel spray from the high-pressure fuel lines, always discharge fuel system pressure before removing any fuel system components.
    1. GTY1132685Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      1. Using a 17 mm union nut wrench, loosen the 2 union nuts of the No. 1 fuel pipe sub-assembly.
      2. Loosen the 2 bolts of the fuel (engine room side) pump assembly.
      3. Remove the No. 1 fuel pipe sub-assembly from the fuel delivery pipe sub-assembly and fuel (engine room side) pump assembly.
  15. REMOVE FUEL (ENGINE ROOM SIDE) PUMP ASSEMBLY 
    NOTE:

    When replacing the fuel (engine room side) pump assembly, it is necessary to replace the No. 1 fuel pipe sub-assembly with a new one.
    1. GTY1129696Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  16. REMOVE FUEL PUMP SPACER GASKET 
    1. GTY1132827Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  17. REMOVE FUEL PUMP LIFTER ASSEMBLY 
    1. GTY1132828Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals