- REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY
Refer to REMOVAL [10/2022 - 08/2023]
- REMOVE E.F.I. VACUUM SENSOR ASSEMBLY (MANIFOLD ABSOLUTE PRESSURE SENSOR)
Refer to REMOVAL [10/2022 - ]
- REMOVE PURGE VALVE (PURGE VSV)
Refer to REMOVAL [10/2022 - 08/2023]
- DISCONNECT NO. 1 FUEL VAPOR FEED HOSE
Refer to PROCEDURE - Step 2
- DISCONNECT NO. 2 FUEL VAPOR FEED HOSE
Refer to PROCEDURE - Step 3
- DISCONNECT ENGINE WIRE
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE NO. 1 EGR PIPE SUB-ASSEMBLY
Refer to PROCEDURE - Step 5
- REMOVE EGR VALVE ADAPTER GASKET
Refer to PROCEDURE - Step 6
- REMOVE EGR INLET GASKET
Refer to PROCEDURE - Step 7
- DISCONNECT NO. 5 WATER BY-PASS HOSE
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- DISCONNECT NO. 3 WATER BY-PASS PIPE
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Using an 8 mm socket wrench, remove the bolt and disconnect the No. 3 water by-pass pipe from the intake manifold.
- REMOVE NO. 2 WATER BY-PASS PIPE
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Disengage the wire harness clamp.
- Using an 8 mm socket wrench, remove the 2 bolts (A) and separate the No. 2 water by-pass pipe from the intake manifold.
- Remove the bolt (B) and No. 2 water by-pass pipe from the cylinder block sub-assembly.
- REMOVE NO. 2 FUEL VAPOR FEED HOSE
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE INTAKE MANIFOLD
- w/ Stud Bolt:
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- Remove the 3 bolts and 2 nuts.
- Using an E8 "TORX" socket wrench, remove the 2 stud bolts and intake manifold from the cylinder head sub-assembly.
- w/o Stud Bolt:
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE NO. 1 INTAKE MANIFOLD TO HEAD GASKET
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE NO. 1 ENGINE COVER
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|
- REMOVE VACUUM HOSE
 Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
|