Installation [10/2022 - ]: Procedure

1. Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a	-3° to 3°	*b	SST Bolt Position
   	Front of Vehicle	-	-

   1. Using SST, install a new rear No. 1 differential mount cushion.
      • SST: 09570-48010 

      Standard Distance (A)

      10.5 to 11.5 mm (0.414 to 0.452 in.)

      NOTE:

      • Make sure that the rear No. 1 differential mount cushion is aligned within 3° from the center.
      • Install the rear No. 1 differential mount cushion so that the protrusion is positioned as shown in the illustration.
      • Be sure to use the correct combination of SST.
      • Before using SST, apply grease to SST bolt.
      • Temporarily install the rear No. 1 differential mount cushion to the rear suspension member sub-assembly in order to prevent it from tilting, and then install SST.
      • Make sure that SST contacts the entire circumference of the rear No. 1 differential mount cushion.
      • Do not tilt the bolts of SST.

Refer to INSTALLATION [10/2022 - ]