DTC P106C-62: Evaporative Emission System Pressure/Barometric Pressure Signal Compare Failure; DTC P106D-62: Evaporative Emission System Pressure Sensor - Turbocharger/Supercharger Boost Sensor Signal Compare Failure [11/2017 - ]: Procedure

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2024 Lexus RC 300, 2023 Lexus RC 300, 2022 Lexus RC 300, 2021 Lexus RC 300, and 2020 Lexus RC 300. However, it is still accessible from the selected car via links, so may be relevant.

CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO P106C-62 AND/OR P106D-62)

Connect the Techstream to the DLC3.
Turn the engine switch on (IG).
Turn the Techstream on.
Enter the following menus: Powertrain / Engine / Trouble Codes.

Read the DTCs.

Powertrain > Engine > Trouble Codes

Result

Result	Proceed to
DTC P106C-62 is output	A
DTC P106D-62 is output	B
DTC P106C-62 and P106D-62 are output	C
DTC P106C-62 and/or P106D-62 and other DTCs are output	D

HINT:

If any DTCs other than P106C-62 and/or P106D-62 are output, troubleshoot those DTCs first.

Result:

See step 3

Result:

See step 4

Result:

GO TO DTC CHART. Refer to DIAGNOSTIC TROUBLE CODE CHART [11/2017 - 10/2018] , or refer to DIAGNOSTIC TROUBLE CODE CHART [10/2018 - 11/2019] , or refer to DIAGNOSTIC TROUBLE CODE CHART [11/2019 - 09/2020] , or refer to DIAGNOSTIC TROUBLE CODE CHART [09/2020 - 10/2022] , or refer to DIAGNOSTIC TROUBLE CODE CHART [10/2022 - ]

Result:

See step 2

REPLACE ECM (ATMOSPHERIC PRESSURE SENSOR)

Replace the ECM (atmospheric pressure sensor).

Refer to REMOVAL [10/2015 - ]

Result

Proceed to
NEXT

Result:

See step 5

REPLACE NO. 2 TURBO PRESSURE SENSOR

Replace the No. 2 turbo pressure sensor.

Refer to PROCEDURE - Step 2

Result

Proceed to
NEXT

Result:

See step 5

REPLACE CANISTER PUMP MODULE

Replace the canister pump module.

Refer to REMOVAL [10/2015 - 09/2020] , or refer to REMOVAL [09/2020 - ]

Result

Proceed to
NEXT

Result:

See step 5

CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED

Connect the Techstream to the DLC3.
Turn the engine switch on (IG) and turn the Techstream on.

Enter the following menus: Powertrain / Engine / Data List / Atmospheric Pressure, Vapor Pressure Pump and Boost Pressure Sensor.

Powertrain > Engine > Data List

Tester Display
Atmospheric Pressure
Vapor Pressure Pump
Boost Pressure Sensor

Confirm that the difference between Atmospheric Pressure and Vapor Pressure Pump is 7.89 kPa [1.14 psi] or less.

Confirm that the difference between Vapor Pressure Pump and Boost Pressure Sensor is 12.4 kPa [1.80 psi] or less.

Result

Proceed to
NEXT

Result:

END