DTC P007A-11: Charge Air Cooler Temperature Sensor Bank 1 Circuit Short to Ground [10/2015 - ]: Procedure
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2024 Lexus RC 300, 2023 Lexus RC 300, 2022 Lexus RC 300, 2021 Lexus RC 300, and 2020 Lexus RC 300. However, it is still accessible from the selected car via links, so may be relevant.
- READ VALUE USING TECHSTREAM (CHECK FOR SHORT IN WIRE HARNESS)
*1 No. 1 turbo pressure sensor *2 ECM - Disconnect the No. 1 turbo pressure sensor connector.
- Connect the Techstream to the DLC3.
- Turn the engine switch on (IG).
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine / Data List / Intake Air Temperature B1S1 (Turbo).
Powertrain > Engine > Data List
Tester Display Intake Air Temperature B1S1 (Turbo) - According to the display on the Techstream, read the Data List.
Standard value
-40°C (-40°F)
Result
Proceed to OK NG
Result:
OK
REPLACE NO. 1 TURBO PRESSURE SENSOR. Refer to PROCEDURE - Step 1
Result:
NG
See step 2
- CHECK HARNESS AND CONNECTOR (NO. 1 TURBO PRESSURE SENSOR - ECM)
- Disconnect the No. 1 turbo pressure sensor connector.
- Disconnect the ECM connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition F82-4 (THIM) or F67-107 (THIM) - Body ground and other terminals Always 10 kΩ or higher Result
Proceed to OK NG
Result:
OK
REPLACE ECM. Refer to REMOVAL [10/2015 - ]
Result:
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR