LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> RC 350 Base, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Engine Cooling System (2GR-FSE) - Service Information) >> Thermostat >> Removal [09/2014 - 11/2017] >> Procedure

Removal [09/2014 - 11/2017]: Procedure

WARNING: This page is about a different car, the 2017 Lexus RC 350, 2017 Lexus RC 300, 2016 Lexus RC 350, 2016 Lexus RC 300, and 2015 Lexus RC 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE ENGINE ROOM SIDE COVER 

    Refer to PROCEDURE - Step 1

  2. REMOVE COOL AIR INTAKE DUCT SEAL 

    Refer to PROCEDURE - Step 2

  3. REMOVE V-BANK COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 4 [09/2014 - 10/2015] , or refer to PROCEDURE - Step 4 [10/2015 - 11/2017]

  4. REMOVE INLET NO. 1 AIR CLEANER 

    Refer to PROCEDURE - Step 20 [09/2014 - 10/2015] , or refer to PROCEDURE - Step 20 [10/2015 - 11/2017]

  5. REMOVE CENTER NO. 4 ENGINE UNDER COVER 

    Refer to PROCEDURE - Step 2 [09/2014 - 10/2015] , or refer to PROCEDURE - Step 2 [10/2015 - 11/2017]

  6. DRAIN ENGINE COOLANT 

    See step  5 [09/2014 - 10/2015], or see step  5 [10/2015 - 11/2017]

  7. DISCONNECT NO. 2 RADIATOR HOSE 
    1. Slide the clip and disconnect the No. 2 radiator hose from the water inlet with thermostat sub-assembly.
      GTY467568Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. DISCONNECT NO. 6 WATER BY-PASS HOSE 
    1. Slide the clip and disconnect the No. 6 water by-pass hose from the water inlet.
      GTY418377Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY 
    1. Remove the 3 nuts, water inlet with thermostat sub-assembly and gasket.
      GTY414172Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals