Removal [10/2015 - 11/2017]: Procedure
WARNING: This page is about a different car, the 2017 Lexus RC 350, 2017 Lexus RC 300, 2016 Lexus RC 350, 2016 Lexus RC 300, and 2015 Lexus RC 350. However, it is still accessible from the selected car via links, so may be relevant.
- REMOVE V-BANK COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 4
- DISCHARGE FUEL SYSTEM PRESSURE
Refer to PRECAUTION [09/2014 - 11/2017]
- PRECAUTION NOTE:
After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Refer to PRECAUTION [09/2014 - 11/2017]
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Refer to INITIALIZATION [10/2015 - 11/2017]
- REMOVE ENGINE ROOM SIDE COVER
Refer to PROCEDURE - Step 1
- DISCONNECT NO. 2 VENTILATION HOSE
Refer to PROCEDURE - Step 6
- REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE
Refer to PROCEDURE - Step 7
- REMOVE FUEL PRESSURE PULSATION DAMPER ASSEMBLY