Installation [10/2022 - ]: Procedure

1. Install the steering knuckle to the front upper suspension arm assembly with the nut.

   Torque: 87 N.m (887 kgf/cm, 64 ft.lbf) 

   NOTE:

   Prevent oil from adhering to the threaded and tapered parts.

2. Install a new clip.
   NOTE:

   Further tighten the nut up to 60° if the holes for the clip are not aligned.

1. Install the front lower ball joint assembly to the steering knuckle with the 2 bolts.

   for 2WD 

   Torque: 150 N.m (1530 kgf/cm, 111 ft.lbf) 

   for AWD 

   Torque: 120 N.m (1224 kgf/cm, 89 ft.lbf) 

Refer to PROCEDURE - Step 6

1. Install the front disc brake dust cover to the steering knuckle with the 4 bolts.

   Torque: 8.0 N.m (82 kgf/cm, 71 in.lbf) 

See step  1

See step  2

Refer to PROCEDURE - Step 1

See step  15

See step  5

See step  5

Refer to PROCEDURE - Step 7

See step  4

See step  5

Refer to PROCEDURE - Step 1

1. Install the front disc brake caliper assembly to the steering knuckle with the 2 bolts.

   Torque: 135 N.m (1377 kgf/cm, 100 ft.lbf) 

   NOTE:

   • Do not twist the front flexible hose when installing the front disc brake caliper assembly.
   • Make sure that there is no foreign matter on the threads of the bolt.
   • If a bolt is deformed or damaged, replace it.
   • Do not overtighten the bolts because the steering knuckle is made of aluminum and may be damaged.

See step  12

See step  13

See step  14

Refer to INSTALLATION [10/2022 - ]

Refer to ADJUSTMENT [09/2020 - ]

Refer to TEST MODE PROCEDURE [10/2022 - ]