Installation [10/2022 - ]: Procedure

1. Install the front axle hub sub-assembly to the steering knuckle with the 4 bolts.

   Torque: 68.6 N.m (700 kgf/cm, 51 ft.lbf) 

1. Install the front axle hub sub-assembly and front disc brake dust cover to the steering knuckle with the 4 bolts.

   Torque: 68.6 N.m (700 kgf/cm, 51 ft.lbf) 

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   *a

   Matchmark

   NOTE:

   Align the matchmarks on the front drive shaft assembly and front axle hub sub-assembly

Refer to PROCEDURE - Step 1

1. Install the front disc brake caliper assembly to the steering knuckle with the 2 bolts.

   Torque: 135 N.m (1377 kgf/cm, 100 ft.lbf) 

   NOTE:

   • Do not twist the front flexible hose when installing the front disc brake caliper assembly.
   • Make sure that there is no foreign matter on the threads of the bolt.
   • If a bolt is deformed or damaged, replace it.
   • Do not overtighten the bolts because the steering knuckle is made of aluminum and may be damaged.

1. Clean the threaded parts on the front drive shaft assembly and a new front axle shaft nut using non-residue solvent.
   NOTE:

   • Be sure to perform this work even when using a new front drive shaft assembly.
   • Keep the threaded parts free of oil and foreign matter.
2. Using a 30 mm socket wrench, while applying the brakes, temporarily install the front axle shaft nut.

   Torque: 294 N.m (2998 kgf/cm, 217 ft.lbf) 

   NOTE:

   Stake the front axle shaft nut after inspecting for looseness and runout in the following steps.

   HINT: 

   Keep depressing the brake pedal to prevent the front drive shaft assembly from rotating.

See step  5

Refer to PROCEDURE - Step 7

See step  4

See step  5

Refer to PROCEDURE - Step 1

1. Install the front disc brake caliper assembly to the steering knuckle with the 2 bolts.

   Torque: 135 N.m (1377 kgf/cm, 100 ft.lbf) 

   NOTE:

   • Do not twist the front flexible hose when installing the front disc brake caliper assembly.
   • Make sure that there is no foreign matter on the threads of the bolt.
   • If a bolt is deformed or damaged, replace it.
   • Do not overtighten the bolts because the steering knuckle is made of aluminum and may be damaged.

1. Using a chisel and hammer, stake the front axle shaft nut.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Connect the front skid control sensor wire connector to the front axle hub sub-assembly.
   NOTE:

   Do not twist the front skid control sensor wire when installing it.

1. Install the front speed sensor to the steering knuckle with the 2 bolts.

   Bolt (A) 

   Torque: 6.0 N.m (61 kgf/cm, 53 in.lbf) 

   Bolt (B) 

   Torque: 8.5 N.m (87 kgf/cm, 75 in.lbf) 

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   NOTE:

   Do not twist the front speed sensor when installing it.

Refer to INSTALLATION [10/2022 - ]

Refer to TEST MODE PROCEDURE [10/2022 - ]