LEMON Manuals: Even more car manuals for everyone
Home >> Lexus >> 2024 >> NX 450h+ Base >> Repair and Diagnosis >> Electrical >> Gauges >> Interior Panels / Trim - Service Information (1 Of 2) >> Front Console Box >> Removal [03/2024 - ] >> Procedure

Removal [03/2024 - ]: Procedure

  1. SECURE VEHICLE 
    Refer to PROCEDURE - Step 1
  2. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL 
    1. GTY1053424Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction - -
      1. Open the glove compartment door assembly as shown in the illustration.
      2. Apply protective tape to the area shown in the illustration.
      3. Using a moulding remover, disengage the 5 clips and 5 guides in the order shown in the illustration to remove the lower center instrument panel finish panel.
  3. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY 
    NOTE:

    To prevent damage to the drive mode select switch (combination switch assembly), do not apply excessive force to the drive mode select switch (combination switch assembly).
    1. GTY1059146Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Drive Mode Select Switch (Combination Switch Assembly) - -
      Remove in this Direction - -
      1. Disengage the 4 clips in the order shown in the illustration to remove the upper console panel sub-assembly.
  4. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 1

  5. REMOVE SHIFTING HOLE COVER ASSEMBLY 
    1. GTY1053233Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction - -
  6. REMOVE CONSOLE BOX HOLE COVER 
    1. GTY1053807Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction - -
  7. REMOVE NO. 2 CONSOLE UPPER PANEL GARNISH 
    1. GTY1053870Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction (1) Remove in this Direction (2)
  8. REMOVE NO. 1 CONSOLE UPPER PANEL GARNISH 
    1. GTY1054005Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction (1) Remove in this Direction (2)
  9. REMOVE UPPER REAR CONSOLE PANEL SUB-ASSEMBLY 
    1. GTY1053124Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction - -
  10. REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY 
    Refer to PROCEDURE - Step 9
  11. REMOVE CONSOLE PANEL 
    1. GTY1052941Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction - -
  12. REMOVE UPPER CONSOLE BOX 
    1. GTY1227643Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *A w/ Console Box Illumination Light (Mono-color) *B w/ Console Box Illumination Light (Multicolor)
      *C w/ Wireless Charger - -
      Remove in this Direction - -
  13. REMOVE DOOR SCUFF PLATE ASSEMBLY LH 

    Refer to PROCEDURE - Step 13

  14. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH 

    Refer to PROCEDURE - Step 15

  15. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 
    1. GTY1053782Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *A for Mono-color *B for Multicolor
      Remove in this Direction - -
  16. REMOVE INSTRUMENT PANEL FINISH PANEL 
    1. GTY1053915Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction - -
      1. Apply protective tape to the area shown in the illustration.
      2. Using a moulding remover, disengage the 5 clips and guide as shown in the illustration to remove the instrument panel finish panel.
  17. REMOVE BLE INDOOR DIGITAL KEY RECEIVER ASSEMBLY (w/ Digital Key System) 
    Refer to PROCEDURE - Step 9
  18. REMOVE FRONT NO. 1 CONSOLE BOX INSERT 
    1. GTY1052548Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction (1) Remove in this Direction (2)
  19. REMOVE FRONT NO. 2 CONSOLE BOX INSERT 
    1. GTY1053272Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction (1) Remove in this Direction (2)
  20. REMOVE CONSOLE REAR END PANEL SUB-ASSEMBLY 
    1. GTY1052731Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *A w/ Seat Heater System - -
      Remove in this Direction - -
      1. Apply protective tape to the area shown in the illustration.
      2. Using a moulding remover, disengage the 9 clips as shown in the illustration to remove the console rear end panel sub-assembly.
      3. Disconnect each connector.
  21. REMOVE CONSOLE BOX CARPET 
    1. GTY1053883Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  22. REMOVE NO. 4 CONSOLE BOX MOUNTING BRACKET 
    1. GTY1059083Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  23. REMOVE REAR CONSOLE BOX ASSEMBLY 
    1. GTY1053842Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction (1) Remove in this Direction (2)
  24. REMOVE CIGAR LIGHTER HOLE COVER 

    HINT: 

    Perform this procedure only when replacement of the cigar lighter hole cover is necessary.

    1. GTY1053044Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  25. REMOVE CONSOLE CUP HOLDER BOX SUB-ASSEMBLY 

    HINT: 

    Perform this procedure only when replacement of the console cup holder box sub-assembly is necessary.

    1. GTY1053175Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      *1 Console Compartment Box - -
  26. REMOVE NO. 2 POWER OUTLET SOCKET ASSEMBLY 

    HINT: 

    Perform this procedure only when replacement of the No. 2 console rear end panel is necessary.

    Refer to PROCEDURE - Step 2
  27. REMOVE NO. 2 POWER OUTLET SOCKET COVER 

    HINT: 

    Perform this procedure only when replacement of the No. 2 console rear end panel is necessary.

    Refer to PROCEDURE - Step 3

  28. REMOVE USB CHARGER SOCKET 

    HINT: 

    Perform this procedure only when replacement of the No. 2 console rear end panel is necessary.

    Refer to PROCEDURE - Step 4

  29. REMOVE NO. 2 CONSOLE REAR END PANEL 
    1. GTY1052996Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  30. REMOVE BOX BOTTOM MAT 

    HINT: 

    Perform this procedure only when replacement of the box bottom mat is necessary.

    1. GTY1227426Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Remove in this Direction (1) Remove in this Direction (2)
      1. Turn back the box bottom mat and remove the 2 pieces of double-sided tape as shown in the illustration.
      2. Disengage the 5 claws and 3 guides to remove the box bottom mat as shown in the illustration.
scientia non olet · About LEMON Manuals